Master cylinder / Pushrod alignment HELP!!!!!!!!!!

Suspension Tuning, Troubleshooting, Design and Discussion

Moderators: David Lemmond, Dave Morgan

Post Reply
Message
Author
jcdrags
Posts: 18
Joined: Sun Apr 25, 2010 11:50 pm

Master cylinder / Pushrod alignment HELP!!!!!!!!!!

#1 Post by jcdrags » Sat May 01, 2010 1:41 pm

The brake pedal (aftermarket)in my chassis car is not aligned properly. The push rod that is aftermarket is approximately 8" long and 1" in diameter it is aluminum and has a clevis at one end and is tapped for the pushrod on the other end, the problem is that it is at a slight angle(3/4") and I am concerned about piston drag. The car was like this when I bought it and it was run for several years like this, ,but it bothers me.
I was wondering if I could take the brake pedal tab out of the clevis and bolt it together like that or would it not be safe, If I could put the aluminum rod up against the brake pedal tab and bolt it together it would almost level the rod out.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests