Jetting ?????
Moderator: John_Heard
- John_Heard
- Site Admin
- Posts: 5734
- Joined: Thu May 12, 2005 11:20 am
- Location: Resume Speed, Kansas
- Contact:
Re: Jetting ?????
What jet sizes you got to play with? What pressure was it set at when you made that last run?
My 1971 X275 Nova | Facebook
Re: Jetting ?????
From .100 down and 5.5 6 psi fuel bottle at or near 1000 psi
- John_Heard
- Site Admin
- Posts: 5734
- Joined: Thu May 12, 2005 11:20 am
- Location: Resume Speed, Kansas
- Contact:
Re: Jetting ?????
Ok, according to Koehler's Nitrous Master Program you were at 5.23 N/F Ratio (5.5 psi) with 88/88 jets. Next step leaner would probably be an 88N/84F at 5.5 psi which would give you 5.74 N/F ratio. If it's still fat, then 88N/82F at 5.5 which would be 6.03 N/F ratio - which should start getting lean there, you should look at the plug strap and see where your timing is too. 8 degrees is a good place to start, but it might want a little more or a little less. If you put some more timing in it, it is usually a good idea to add some fuel too at the same time because that's going to put some heat in it - especially when you're getting close on the tune up.
My 1971 X275 Nova | Facebook
Re: Jetting ?????
Mine was built locally and also spent some time in Baton Rouge, LA.eldabo wrote:Yeah Ill do that tomorrow .Did you build you truck or buy it? The reason I ask is there used to be one running around in Mobile Alabama that was just like yours.
Trucks are for haulin...
Re: Jetting ?????
What do you think about going to say a 92 or 94 no2 ?
Re: Jetting ?????
Don't want to sound like a chicken turd, but I would tune what you've got before going to the next step. What I mean is, I would change the fuel jet to a smaller size and make sure all is well before I would go up on the nitrous jet. But, I guess everybody has got their own way.
'87 S10 stock suspension, Caltracs, 9" rearend, 1.82 Glide, 383 SBC,
Brodix Track1 Heads, 14:1 compression, 180 shot plate,
2" tube Hussler Headers, 1.38 60ft., 6.20 ET 1/8th, 109 MPH,
Still Tuning, more to come.
Brodix Track1 Heads, 14:1 compression, 180 shot plate,
2" tube Hussler Headers, 1.38 60ft., 6.20 ET 1/8th, 109 MPH,
Still Tuning, more to come.
Re: Jetting ?????
Thanks Im going to bring a few jets with me and sneak up on the tune .Wish me luck
David
David
Who is online
Users browsing this forum: No registered users and 26 guests