cross plate noise

General Nitrous Discussion

Moderator: John_Heard

Post Reply
Message
Author
zephyrc
Posts: 24
Joined: Wed Jun 24, 2009 12:53 pm

cross plate noise

#1 Post by zephyrc » Sat Jul 17, 2010 8:18 am

i have put my cross plate on the motor and it makes a whistle type noise just as i come of idle.. definitely the plate as if i remove it the noise stops.. any ideas how to stop this

User avatar
Craig W.
Posts: 1257
Joined: Thu May 12, 2005 11:01 am
Location: Columbia, KY
Contact:

Re: cross plate noise

#2 Post by Craig W. » Sat Jul 17, 2010 9:54 am

Possibly a bad gasket cause a vacuum leak? Plate not flat? Spray bars leaking where they meet the plate?
Craig Watson
2QuickNovas Racing
5.23@131

Sponsors:
AEM Electronics
Carnivore Performance
Rapp Racing
VFN Fiberglass
Fast Shafts

zephyrc
Posts: 24
Joined: Wed Jun 24, 2009 12:53 pm

Re: cross plate noise

#3 Post by zephyrc » Sat Jul 17, 2010 11:41 am

new gaskets top and bottom,, plate seems flat with a straight edge.. will check the spraybar where it joins the plate

zephyrc
Posts: 24
Joined: Wed Jun 24, 2009 12:53 pm

Re: cross plate noise

#4 Post by zephyrc » Sun Jul 18, 2010 4:35 pm

checked the spraybars and they seem fine

505r10
Posts: 34
Joined: Sun Apr 11, 2010 6:17 pm

Re: cross plate noise

#5 Post by 505r10 » Wed Jul 21, 2010 8:21 pm

zephyrc wrote:checked the spraybars and they seem fine

Spray a little WD around it when you hit the spot it'll probably shut up momentarily.



Roger
585R10

Post Reply

Who is online

Users browsing this forum: No registered users and 17 guests