Comp cams Nx264hr-14

General Nitrous Discussion

Moderator: John_Heard

Post Reply
Message
Author
talon
Posts: 1
Joined: Mon May 22, 2006 9:59 am

Comp cams Nx264hr-14

#1 Post by talon » Tue May 23, 2006 7:05 am

Good morning

has anyone used this cam B4?

We have a 2900Lb 64 Falcon

Motor is a 5.0, rpm air gap, 600cfm, E7 heads I 213cfm@.55/ E 187cfm @.55 all at 28" of water.

Trans is C4/3500 stall TCI and 3:80 gears, 26 x 8 MT.

I was also wondering to get a little more lift and still keep the same valve seat to seat events I would like to use a 1:7 rocker.

Camshaft Specification Table
Part Number 35-552-8
Engine 1969-1995 Ford
351ci,
Windsor,
8cyl.
Grind Number FW NX264HR-14
Description

--------------------------------------------------------------------------------

Intake Exhaust
Valve Adjustment 0 0
Gross Valve Lift 0.512 0.512
Duration At 0.006 Tappet Lift 264 276

--------------------------------------------------------------------------------

Valve Timing At 0.006
Open Close
Intake 22 62
Exhaust 76 20

--------------------------------------------------------------------------------

These Specs Are For The Cam Installed At 110 Intake CL
Intake Exhaust
Duration At 0.05 212 218
Lobe Lift 0.32 0.32
Lobe Separation 114

--------------------------------------------------------------------------------

Recommended Valve Springs 986-16


any thoughts welcome

Thanks in advance
Jim

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest