Page 2 of 2
Posted: Sat May 26, 2007 2:22 pm
by a1elec
i always thought taylor was kind of a generic wire. how do they hold up under heat? john
Posted: Sat May 26, 2007 3:54 pm
by sc racing
As long as they dont actually touch the header they hold up just fine.I think they are one of the best.
Posted: Sat May 26, 2007 8:17 pm
by Bad67
I ran taylor wires for years never had a problem with them until now,when i switched cylinder heads all of a sudden my wires were alot closer to the header than before.so i just prchased a new set of msd 8.5 super conductors part# 31239