Ford 9 Inch ring and pinion

Everything from the motor to the wheels

Moderator: John_Heard

Message
Author
User avatar
Blade
Posts: 321
Joined: Mon Jan 18, 2010 7:24 am
Location: Deale, MD

Re: Ford 9 Inch ring and pinion

#16 Post by Blade » Tue Nov 22, 2011 5:25 pm

want-a-be wrote:Sounds like you need to find out what is in the lower end of your engine. If it would hold up to the rpm,...I'd stretch it out to at least 7k or so. I sti;; think you'll end up putting your old gears back in the long run.

Need to revisit this question after you find out what is in the engine,...Carb to pan.

Don

Why u think that?
1967 Camaro

Hey I gotta 9 sec car, in the 8th! lol

Jegs
Mike Curley Racing
Capital Raceway
Maryland International Raceway

want-a-be
Posts: 189
Joined: Tue Feb 05, 2008 11:04 pm
Location: Southern Illinois

Re: Ford 9 Inch ring and pinion

#17 Post by want-a-be » Tue Nov 22, 2011 6:10 pm

Because,...imo of course,...your shift points are too low and your trap rpm seems low also. I run stock cast cranks harder then you're running this thing. Even in circle tracks dirt scene.

I'm not always correct by any means,..and I may tend to run the stuff I am involved with pretty hard,...but it lives and usually runs pretty good for some reason. Well as good as the chosen parts will allow.

Probably ought to do you own thing and not listen to anything I have to say. There is a reason for my screen name on these forums after all...lol :roll:

Don

Post Reply

Who is online

Users browsing this forum: No registered users and 27 guests