I have an old Lincoln weldpack 100 mig.
I've been looking for a 220v, probably a Miller
even though my old lincoln was a good welder.
I'be got my eye on thier Millermatic DVI 2 #907323,
but they have a Millermatic 212 #907324
for a couple hundred more.
The DVI will run 110 or 220, just not sure the reliability on them.
http://www.millerwelds.com/
Any ideas would be greatly appreciated
mig welders
Moderator: John_Heard
-
- Posts: 238
- Joined: Thu Oct 12, 2006 1:12 pm
- Location: Colonial Beach VA If I am not at home or the track then I am probably at HOOTERS
I have a large snap-on mig and a miller plasma cutter, Not sure of the weldersize but it said up to 3/8 but it will blow holes in 7/8 steel, bad-ass welder
74 chevy luv 355 sbc bracket car
70 Nova SS bracket / t.n.t car.
(Yes REAL SS 396 DISCS 12B0LT ETC)
WANTED DEAD OR ALIVE 68-74 NOVAS
TOO MUCH IS NOT ENOUGH!!!!!!!!!!!!!!!!
70 Nova SS bracket / t.n.t car.
(Yes REAL SS 396 DISCS 12B0LT ETC)
WANTED DEAD OR ALIVE 68-74 NOVAS
TOO MUCH IS NOT ENOUGH!!!!!!!!!!!!!!!!
Who is online
Users browsing this forum: No registered users and 8 guests