driveshaft RPM how to?
Posted: Sun Jun 11, 2006 6:20 pm
Hello,
I'm seriously considering purchasing the basic data logger kit. I'd like to know how the magnets should be attached to the pinion yoke. One person mentioned drilling holes and epoxying the magnets in while on the web site I see two slip collars.
Here's what my pinion setup looks like on a 12 bolt Chevy with a Denny's Driveshaft 1350 series billet yoke.
The shank portion where the seal rides is 1.750" diameter and the gap between the pinion seal and the step is right around .300".
Where are the magnets/slip collor typically located?
I assume due to forward/rearward movement that attaching the slip collar to the pinion yoke would not work?
Thanks
Todd
I'm seriously considering purchasing the basic data logger kit. I'd like to know how the magnets should be attached to the pinion yoke. One person mentioned drilling holes and epoxying the magnets in while on the web site I see two slip collars.
Here's what my pinion setup looks like on a 12 bolt Chevy with a Denny's Driveshaft 1350 series billet yoke.
The shank portion where the seal rides is 1.750" diameter and the gap between the pinion seal and the step is right around .300".
Where are the magnets/slip collor typically located?
I assume due to forward/rearward movement that attaching the slip collar to the pinion yoke would not work?
Thanks
Todd