one quick question
Posted: Fri Jun 30, 2006 9:26 pm
I've ready through the instuctions on the RPM DL10. The recording start rpm's (autostart) have me a tad confused. The examples given were for t-brake cars. I typically prestage at an idle, then wait for my competitor to prestage. I then will raise my rpms watching the tach then bump in for final staging. Due to this proceedure, I'm at stage rpm a bit longer than a t-brake car.
I typically footbrake my car at between 1800 to 2500 rpm. I think I used an initial record start rpm of around 1700 rpm. Also, I think I set the driveshaft rpm at 500 rpm.
Am I in the ballpark with these settings, or do I need to tweak these parameters?
Got everything done and did a test in the garage on stands and everthing seems to be working fine and will be testing on Sunday at my next race.
Looking forward to seeing what kind of results/data I see after using this for a while.
BTW, big thanks to Randy for getting the cables back to me in time to be able to use the system this weekend!
thanks
Todd
I typically footbrake my car at between 1800 to 2500 rpm. I think I used an initial record start rpm of around 1700 rpm. Also, I think I set the driveshaft rpm at 500 rpm.
Am I in the ballpark with these settings, or do I need to tweak these parameters?
Got everything done and did a test in the garage on stands and everthing seems to be working fine and will be testing on Sunday at my next race.
Looking forward to seeing what kind of results/data I see after using this for a while.
BTW, big thanks to Randy for getting the cables back to me in time to be able to use the system this weekend!
thanks
Todd