MSD dist cap
Moderator: John_Heard
MSD dist cap
Since I can't get a response from msd, I'll ask on here. I have a crank trigger dist with the crab style cap, I want to put the large cap with more spacing on it, does anyone have a pt no? I think it is the 7445 but not for sure. Also, what kinda wires do you all run with a dig 7 ign? I normally run the Moroso's and I'm due for a new set. Thanks
- John_Heard
- Site Admin
- Posts: 5734
- Joined: Thu May 12, 2005 11:20 am
- Location: Resume Speed, Kansas
- Contact:
Re: MSD dist cap
Is it the Jesel front belt drive setup or stock position? I need to look this shit up too and get a new cap and rotor on order.
I've used MSD wires and Moroso wires in the past. I'll probably try the Firecore brand next time, - http://www.firecore50.com/ everyone seems to like them quite well and good service.
I've used MSD wires and Moroso wires in the past. I'll probably try the Firecore brand next time, - http://www.firecore50.com/ everyone seems to like them quite well and good service.
My 1971 X275 Nova | Facebook
Re: MSD dist cap
John, it's in the rear, regular location. It's an old crab style cap dist. It's got the plastic disc or whatever you want to call it that is held down with 1 screw that the rotor button attaches to. The screw wants to work loose so every so often I ck it and reloctite it. Bad setup.
-
- Posts: 6
- Joined: Tue Dec 04, 2012 10:51 am
Re: MSD dist cap
vht wrote:Since I can't get a response from msd, I'll ask on here. I have a crank trigger dist with the crab style cap, I want to put the large cap with more spacing on it, does anyone have a pt no? I think it is the 7445 but not for sure. Also, what kinda wires do you all run with a dig 7 ign? I normally run the Moroso's and I'm due for a new set. Thanks
unfortunately, you cannot interchange those caps...the 8489-84891 shaft-base and lower housing .....is totally different then the 84697/8558
http://www.msdignition.com/product.aspx ... terms=8558
http://www.msdignition.com/product.aspx ... erms=84697
Who is online
Users browsing this forum: No registered users and 3 guests