Wrist pin groove deburr tool

Fabrication, Welding, Shop Tools, Tips & Techniques

Moderator: John_Heard

Post Reply
User avatar
Site Admin
Posts: 5684
Joined: Thu May 12, 2005 11:20 am
Location: Resume Speed, Kansas

Wrist pin groove deburr tool

#1 Post by John_Heard » Sat Dec 20, 2014 11:26 pm

Been having full removing tru-arcs from my pistons, which often kicks up a little burr. That in turn makes it hard to get the pins out. After screwing around with a few different things to knock the burrs down I came up with this. It's just a old used pin with a cutter ground into the end of it. hard to see it but there is relief ground into the end so it will cut. Works pretty good.

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests