General Gauges, Wiring, Ignition..
Moderator: John_Heard
-
a1elec
- Posts: 241
- Joined: Sun Jan 22, 2006 1:47 pm
- Location: chicago
#16
Post
by a1elec » Sat May 26, 2007 2:22 pm
i always thought taylor was kind of a generic wire. how do they hold up under heat? john
-
sc racing
- Posts: 1773
- Joined: Sun Jun 11, 2006 1:45 pm
- Location: Sahuartia Az
#17
Post
by sc racing » Sat May 26, 2007 3:54 pm
As long as they dont actually touch the header they hold up just fine.I think they are one of the best.
-
Bad67
- Posts: 91
- Joined: Fri Apr 06, 2007 11:08 am
- Location: Newark,Delaware
#18
Post
by Bad67 » Sat May 26, 2007 8:17 pm
I ran taylor wires for years never had a problem with them until now,when i switched cylinder heads all of a sudden my wires were alot closer to the header than before.so i just prchased a new set of msd 8.5 super conductors part# 31239
Who is online
Users browsing this forum: No registered users and 5 guests