11.4:1 pump gas + nitrous

General Nitrous Discussion

Moderator: John_Heard

Post Reply
Message
Author
Rice Killer
Posts: 19
Joined: Fri Jun 22, 2007 10:49 pm
Location: Maple Grove, MN

11.4:1 pump gas + nitrous

#1 Post by Rice Killer » Wed Jul 18, 2007 10:57 pm

Is it safe to run 92 octane on a 150 shot?

I'm trying to figure out if I should buy a 1 gallon cell with a seperate pump and reg. and fill it with 110.

Is that overkill? I just don't want to take any chances of hurting the motor.

andrew

User avatar
rustbucket
Posts: 566
Joined: Tue Aug 15, 2006 6:36 pm
Location: central alabama

#2 Post by rustbucket » Wed Jul 18, 2007 11:03 pm

Yes! Your carb and nitrous need different fuel pressures. If you run a really big fuel pump in the rear, you can split the fuel with 2 regulators and it will work. If you want to be as safe as possible, dedicate a cell, pump and regulator to the nitrous and run race fuel.
406sbc, powerglide, nitrous
http://youtube.com/watch?v=DssW5vc_t3k

User avatar
John_Heard
Site Admin
Posts: 5734
Joined: Thu May 12, 2005 11:20 am
Location: Resume Speed, Kansas
Contact:

#3 Post by John_Heard » Thu Jul 19, 2007 6:43 am

Agreed - If you really want to be safe put the 110 in both tanks , might not be 100% necessary at that level but it will be safer.

Rice Killer
Posts: 19
Joined: Fri Jun 22, 2007 10:49 pm
Location: Maple Grove, MN

#4 Post by Rice Killer » Thu Jul 19, 2007 7:45 am

If I did go with a 1 gallon cell, how long would that last while spraying a 150 shot? 2 runs? 3 runs?

thanks
andrew

User avatar
John_Heard
Site Admin
Posts: 5734
Joined: Thu May 12, 2005 11:20 am
Location: Resume Speed, Kansas
Contact:

#5 Post by John_Heard » Thu Jul 19, 2007 8:55 am

Quite a while, you're going to use approximately .04 gallons in 10 seconds

Rice Killer
Posts: 19
Joined: Fri Jun 22, 2007 10:49 pm
Location: Maple Grove, MN

#6 Post by Rice Killer » Thu Jul 19, 2007 9:20 am

Thanks for the help! I'm going to go the 1 gallon cell and a summit pump and reg. combo.

andrew

Post Reply

Who is online

Users browsing this forum: Google [Bot] and 7 guests