Yep, still around. And the older I get, the rounder I get.

That booger sure sounds good ! And looks good too, once you adjust to that pumpkin glow :) Same old thing here - still tweaking and building, getting ever closer to making noise. I've been three months away from engine start for over three years now. You know how that goes. It's amazing how many thi...

Bruce !!!! Did you break your old rearend ? You're putting it back on the street ? When did you have to take it off the street, and why ? Did you break things, radically upscale things, decide to accept a real challenge and install a blue oval drive train ? What gives ? laffin... Me, I'm still hamme...

Thats what I'm saying, I'm trying to get back into racing, and might have some questions to ask, and it's better to go here then try to spend hours researching on the internet. IDK, man There are some pretty experienced folks hanging out here and a lot of good tech info in the post history. What so...

This is my first experience with Dart Big-M blocks. The whole priority main oiling thing was new to me, as was the need to tweak top end oil flow volumes. I'm running Isky Ezy-X solid bush rollers and .120 thick wall pushrods, feeding T&D rockers. In priming the motor on the stand I discovered t...

I haven't been on the track in a long time. I'm hoping to get the Camaro back on the street soon and chasing the stripe shortly after that. I'll need to do it the right way - this is my first EFI build and it's pretty obnoxious - it'll take time to get the tune dialed in. Should be pushing something...

Wow, 1.051 in the 60 is cookin !!! Whats your mph across the stripe ?

Hows the Nova running ? I'm getting ready to fire a new build - seems like it's taken forever to get to this point...

Somebody recently posted a reply to a thread I was following here and I got an email notification on it. That's the first I've seen from DragStuff in a long long time. Are you guys still hanging out here ? I've been busy building new stuff but have been focused on Facebook with the various performan...

bruce, I'd pull the rear end and replace the housing tube ends with ford or olds bearing housing ends. That way you can replace the c-clip setup and go with stouter aftermarket axles. It's not cheap, but it is good insurance. I can provide you with the design drawings I did when I did that for mine....

I ran the conventional MSD Blaster 2 cannister coil for quite a while before jumping over the the solid state MSD Blaster SS coil. When using that conventional coil design you have to make sure you don't install it laying down - it needs to be standing up, vertically. I found that I would develop a ...

What coil are you running, and, what's your comp ratio ? I run my plugs at .030 - pretty tight but then my dynamic compression under boost is pretty ugly.

Also, check how hot/cold your plugs are and see what others are running for your build.

Just some thoughts...

Of course if you lived in Sacramento, you could be busy planning your runs during the annual New Years Day Drag Race Event at Sacramento Raceway. If you lived in Sacramento.

Yay !!!! Great work - it sounds like you're back in business :)