Gotcha. will test car in 2 weeks. Thanks

the sw invoice says hal corp aluminum single adjustable 2 1/4 travel #50-017a I also have 450lb spring since its a b1 and all iron indy max wedge block. The car scaled 49.7 rear / 50.3 front. not much front end movement I assume at 2 1/4 ".

Thanks Don, I will follow your instructions. The car was scaled and we had adjusted the 1 bar to even out the weight If I move the bar down will the car need to be re-scaled ? what is your thought on the shock settings? The car has less front end travel with the coil overs then with the old torsion ...

I recently installed a sw front clip and rack system and a arm coil springs in my 69 dart. the engine to clear the oil pump went back 5" and is 7 1/2 inches off the ground from crank center. this puts the trans tail shaft 1 1/2 higher then the rear end pinion center. I set the pinion angle at 2...