Page 1 of 1
Nova motor plate--small block
Posted: Fri Mar 25, 2011 8:04 pm
by Craig W.
I'd like to see some pics from you guys running front motor plates on your small block Novas. I've got my ideas of how I might make my mounts but would like to see what others have done. I've seen quite a few big block cars but the plate is further forward than where mine will be. Thanks.
Re: Nova motor plate--small block
Posted: Mon Mar 28, 2011 6:36 am
by luv454
I notched my frame crossmember and fit a piece of angle iron in. I welded two 7/16 nuts on the back side so all you have to do is thread the bolt through. Use plenty of anti seize when you weld the grade 8 nut so it won't gall the threads. I don't know how to attach a picture here but if you email me I can send them to you.
jamie.carroll@talecris.com
Re: Nova motor plate--small block
Posted: Mon Mar 28, 2011 7:46 am
by Craig W.
Just dropped you an e-mail. I'd love to see some pictures of how you did yours.
Thanks.
Re: Nova motor plate--small block
Posted: Thu Apr 21, 2011 7:42 pm
by 71 Nova
Here are some pics of the motor plate I'm working on for my Camaro. I'm converting from BBC to SBC. I carved it out of a Comp Engineering PN C4004 rectangular aluminum piece. Still need to weld on the tabs to the crossmsmber. Let me know if you need any more pics.
Ken
Re: Nova motor plate--small block
Posted: Thu Apr 21, 2011 7:43 pm
by 71 Nova
A few more pics...
Re: Nova motor plate--small block
Posted: Tue Apr 26, 2011 12:01 am
by Craig W.
Thanks for the pics. I appreciate it.
I've just about got the motor plate finished. I haven't worked on it for a bit. I finally got some motor parts in and I've been mocking up the new setup. Dropped it off at the machine shop this afternoon. Hopefully I'll be assembling it in about two weeks.