Page 1 of 1

Neat Engine Lift Plate / Load Balancer

Posted: Tue Oct 09, 2007 1:00 pm
by John_Heard
Ran across this the other day - neat idea... I want one!

Image

http://www.kaizen-ms.com/lift_plte.html

Posted: Tue Oct 09, 2007 6:41 pm
by a1elec
i was always afraid to lift a motor by the carb studs. i have one that is similar but has 4 chains that go front and back of the heads. 57.00 at local parts store.

Posted: Tue Oct 09, 2007 6:53 pm
by John_Heard
I've got one of those too, it gets the job done. This thing looks neat though and would let you get some more height out of your lift I think.

Load Leveling Lift Plate

Posted: Tue Oct 09, 2007 10:11 pm
by Cogan
Hi guys,
I had the same reservations about four carb studs on an aluminum manifold lifting a BBC over my Camaro. So when I designed this plate, I had two of them destroyed to find out whether my fears were warranted. Long story short, the plate failed around 8000 lbs on both an iron and alum manifold. The alloy steel carb studs could be unscrewed by hand after the test. I thought for sure the studs would pull out of the aluminum first but the myth was busted. You can see my test results in the tech section of the Kaizen Motorsports website. Take care guys.

Chris Cogan
Kaizen Motorsports

Posted: Wed Oct 31, 2007 7:01 pm
by dadnova
The carb plates work great, I have pulled countless of engines with them, just use the longest bolt you can on the intake and still be tight to the plate. I made my own for $2.50. Instead of the bar on the one's you buy I put an eye bolt(welded closed of course) so I can rotate the engine.