oil rings
Posted: Mon Sep 08, 2014 5:37 pm
I have a 468 Chevy big block, rebuilt it about 7 years ago but haven't really run it much at all, so I toke my heads off and looked at the cylinders and everything and noticed a little oil in the cylinders, each time I would rotate the engine it would get a little oil back in the cylinder after a couple revolutions, my question is could this be normal or not? I don't have very much run time on this engine, all new piston and oil rings gaped and installed correctly all new bearings the cylinders where honed before installation. any thoughts or insight on this would be greatly appreciated.