1/8 fitting

General Nitrous Discussion

Moderator: John_Heard

Post Reply
Message
Author
dcw9360
Posts: 27
Joined: Thu Mar 17, 2011 2:50 pm

1/8 fitting

#1 Post by dcw9360 » Tue May 10, 2011 6:31 pm

Where can I find an 1/8" to 1/8" npt 45 degree fitting ??? Need to angle my solenoid for clearance!!!
Thanks

User avatar
John_Heard
Site Admin
Posts: 5734
Joined: Thu May 12, 2005 11:20 am
Location: Resume Speed, Kansas
Contact:

Re: 1/8 fitting

#2 Post by John_Heard » Tue May 10, 2011 10:00 pm

If you're looking for brass, I would bet McMaster Carr stocks it - http://www.mcmaster.com/

dcw9360
Posts: 27
Joined: Thu Mar 17, 2011 2:50 pm

Re: 1/8 fitting

#3 Post by dcw9360 » Tue May 10, 2011 10:07 pm

John_Heard wrote:If you're looking for brass, I would bet McMaster Carr stocks it - http://www.mcmaster.com/
CANT FIND ONLINE THERE EITHER....

71Hellride
Posts: 80
Joined: Sat May 30, 2009 7:35 pm

Re: 1/8 fitting

#4 Post by 71Hellride » Tue May 10, 2011 11:31 pm

Grainger has them, but I can only find them in a 10 pack.

http://www.grainger.com/Grainger/Street ... Pid=search

Mcmaster has these

http://www.mcmaster.com/#brass-pipe-str ... ws/=c93ndi

I have a grainger close to the house and buy most stuff from there. If they don't have it they always get it the next morning.

User avatar
wikd69
Posts: 2077
Joined: Sat Feb 23, 2008 12:42 pm
Location: Rocklin, CA
Contact:

Re: 1/8 fitting

#5 Post by wikd69 » Wed May 11, 2011 12:44 am

dcw9360 wrote:
John_Heard wrote:If you're looking for brass, I would bet McMaster Carr stocks it - http://www.mcmaster.com/
CANT FIND ONLINE THERE EITHER....
Go find your local Ace Hardware store. Around here they have a far better selection on nuts and bolts and fitting than most other places, at least in this area. Thats where I get all my stainless and grade-8 stuff as well as a lot of my brass fittings.
1969 ProStreet Camaro RS Best 9.75@139 1.46 60'
Blown 427 BBC, TH400 w/Brake, Back-Half Ladderbar
Narrowed 12-Bolt, 4.10 Gears, Spool, Moser 33 Spline

http://www.marsh-racing.com/harrys_camaro-1.htm

Post Reply

Who is online

Users browsing this forum: No registered users and 13 guests