4150 plate under a Dominator adapter
Moderator: John_Heard
4150 plate under a Dominator adapter
Of course I'd be crazy to do it after paying to have Mike blend my adapter into my intake, but I guess it would work OK. I've never seen it done, but I'm sure there's someone out there like me that hasn't bought a 4500 plate yet, but wants to try a Dominator.
Craig Watson
2QuickNovas Racing
5.23@131
Sponsors:
AEM Electronics
Carnivore Performance
Rapp Racing
VFN Fiberglass
Fast Shafts
2QuickNovas Racing
5.23@131
Sponsors:
AEM Electronics
Carnivore Performance
Rapp Racing
VFN Fiberglass
Fast Shafts
- John_Heard
- Site Admin
- Posts: 5734
- Joined: Thu May 12, 2005 11:20 am
- Location: Resume Speed, Kansas
- Contact:
How about you bring it to Amarillo. I'm going to start the new motor with the 4150 carb and be sure its healthy with a carb that I know is jetted about right. Then later on I'll try the Dominator and see what it does. So I don't think I'll need the 4500 plate before then.
Thanks!
Thanks!
Craig Watson
2QuickNovas Racing
5.23@131
Sponsors:
AEM Electronics
Carnivore Performance
Rapp Racing
VFN Fiberglass
Fast Shafts
2QuickNovas Racing
5.23@131
Sponsors:
AEM Electronics
Carnivore Performance
Rapp Racing
VFN Fiberglass
Fast Shafts
- John_Heard
- Site Admin
- Posts: 5734
- Joined: Thu May 12, 2005 11:20 am
- Location: Resume Speed, Kansas
- Contact:
I think I'd figure out wich carb I was going to keep then go for the nitrous plate from there.
If you end up using an adapter plate, you could always put nozzles in it rather than adding a spray bar style plate.
I plan on putting some nozzles in my spacer plate sometime here in the future. :)
If you end up using an adapter plate, you could always put nozzles in it rather than adding a spray bar style plate.
I plan on putting some nozzles in my spacer plate sometime here in the future. :)
- Greg
That's what I'm going to do. I'm building a new engine and I'll start out with my tried and true HP1000 Holley and once I've got some clean runs under my belt with the new setup, I'll start working with the Dominator.
I've already got the 4150 plate and John is going to let me use his 4500 plate, so I should be good to go.
Thanks.
I've already got the 4150 plate and John is going to let me use his 4500 plate, so I should be good to go.
Thanks.
Craig Watson
2QuickNovas Racing
5.23@131
Sponsors:
AEM Electronics
Carnivore Performance
Rapp Racing
VFN Fiberglass
Fast Shafts
2QuickNovas Racing
5.23@131
Sponsors:
AEM Electronics
Carnivore Performance
Rapp Racing
VFN Fiberglass
Fast Shafts
Who is online
Users browsing this forum: No registered users and 38 guests