Page 1 of 1
Need Some Torque Specs.
Posted: Wed May 14, 2008 5:37 pm
by MMAX
What's the torque specs for the trans bellhousing to the engine and for the converter to the flexplate?
Posted: Fri May 16, 2008 1:37 pm
by stroker1
WHITE KNUCKLES!! Hee, hee, hee!!
Posted: Fri May 16, 2008 3:59 pm
by MOOSE
I usually end up with bloody ones when it comes to those areas!!!!!
MOOSE
Posted: Sun May 18, 2008 4:29 pm
by Goat Hearder
Just use factory specs for application if you want and add loctite to converter bolts. I think most folks just tighten the crap out of them! If I recall most bell bolts are about 35-40 and the converter to flex is around 35-45 dependent on size and number.
Posted: Sun May 18, 2008 6:47 pm
by MMAX
Thanks for the replies. I did a bit of reading and went with 25 ft/lbs for the bell to the engine and tightened the hell out of the convertor to flexplate bolts.