shifter problems
Posted: Sat Jun 30, 2012 6:10 pm
Just rebuilt the powerglide and now I got shifter linkage problem. I'm using a B&M pro ratchet
and when I put the shifter into low gear and make sure the fitting goes into the shifter
bracket with no problem. But when I move the linkage to park and then move the shifter into
park, I have to turn the fitting out three turns to get the fitting to slide in.
Then back into low again and I now how to turn the fitting in, three turns.
All we did was rebuild it and now I can't get the shifter linkage to work. Had no problems
before this.
Any thoughts?
and when I put the shifter into low gear and make sure the fitting goes into the shifter
bracket with no problem. But when I move the linkage to park and then move the shifter into
park, I have to turn the fitting out three turns to get the fitting to slide in.
Then back into low again and I now how to turn the fitting in, three turns.
All we did was rebuild it and now I can't get the shifter linkage to work. Had no problems
before this.
Any thoughts?