Page 1 of 1

no turning back now...

Posted: Sun Jan 06, 2013 7:31 pm
by Hitchcock
As if the back half job was not the turning point. Today I final fitted the mid and front engine plates. And then grit my teeth and cut the frame mounted motor mounts off. I still cringe a little cutting stock stuff off the car. :?

Re: no turning back now...

Posted: Sun Jan 06, 2013 7:50 pm
by wikd69
Hitch, we need pix !!!!!

I'm really jonesing for shop porn - I've been heads down cutting code on a software development project and only see the Camaro when my wife needs something from the garage. :(

I'm planning on attending a week-long event in mid-April with the hotrod so I really need to get my butt downstairs and back out in the shop again soon. Until then though, I'll have to live vicariously through you :smt003

Re: no turning back now...

Posted: Sun Jan 06, 2013 8:15 pm
by Hitchcock
LOL, then you'll be bored. I will get some up soon.

Re: no turning back now...

Posted: Tue Jan 08, 2013 10:42 am
by Bruce69Camaro
I thought you were going to tell us that you were finally getting married and going to Florida on your honeymoon.....

Oh wait, that did happen, just get us some pictures of the car!

Hey if you want, I'll come out and cut whatever you want off of your car...I have no problem cutting things off of it... :smt005 :smt005

That would also give me an excuse to hunt down the guy they call Mike Peters and eat some of those famous deep fried green beans.

Re: no turning back now...

Posted: Tue Jan 08, 2013 2:03 pm
by Hitchcock
Bruce, all you have to do is show up. Ill give you so much to do, you'll never want to come back to Kansas. As far as Mike, ill have to convince him to bring me some of those things. Then decide if they are better than tgifridays.

Re: no turning back now...

Posted: Tue Jan 08, 2013 2:07 pm
by Bruce69Camaro
If I keep the snoring up, I may be out there with you guys for good!