Window net and welding question
Posted: Wed Apr 26, 2006 2:06 pm
Two question for you guys. First off, my car has a 4130 chromoly cage installed. I know it has to be TIG welded. That was all done by the shop that installed it so we are all good on that. I need to add a tab to the crossbar for the shoulder belts and a couple of tabs for the window net. Can I just MIG them or do I need to have them TIG'ed as well????
Retrofitting a new window net into the car and it's smaller than the original one that was installed. The front of the window net does not come all the way down to the door bar. What's the best way to mount the front lower window net bar to the door bar? There is a gap of about 4" or so. I've seen some that use some type of cable and that seems like it might be easiest. Is there anything special about the cable or is it just stuff I can get at the local hardware store??/
Thanks
Ron
71 Nova
Retrofitting a new window net into the car and it's smaller than the original one that was installed. The front of the window net does not come all the way down to the door bar. What's the best way to mount the front lower window net bar to the door bar? There is a gap of about 4" or so. I've seen some that use some type of cable and that seems like it might be easiest. Is there anything special about the cable or is it just stuff I can get at the local hardware store??/
Thanks
Ron
71 Nova