Wrist pin groove deburr tool

Fabrication, Welding, Shop Tools, Tips & Techniques

Moderator: John_Heard

Post Reply
Message
Author
User avatar
John_Heard
Site Admin
Posts: 5734
Joined: Thu May 12, 2005 11:20 am
Location: Resume Speed, Kansas
Contact:

Wrist pin groove deburr tool

#1 Post by John_Heard » Sat Dec 20, 2014 11:26 pm

Been having full removing tru-arcs from my pistons, which often kicks up a little burr. That in turn makes it hard to get the pins out. After screwing around with a few different things to knock the burrs down I came up with this. It's just a old used pin with a cutter ground into the end of it. hard to see it but there is relief ground into the end so it will cut. Works pretty good.
Attachments
deburr-tool.jpg

Post Reply

Who is online

Users browsing this forum: No registered users and 16 guests