Fabrication, Welding, Shop Tools, Tips & Techniques
1 post •Page 1 of 1
- Site Admin
- Joined:Thu May 12, 2005 11:20 am
- Location:Resume Speed, Kansas
Been having full removing tru-arcs from my pistons, which often kicks up a little burr. That in turn makes it hard to get the pins out. After screwing around with a few different things to knock the burrs down I came up with this. It's just a old used pin with a cutter ground into the end of it. hard to see it but there is relief ground into the end so it will cut. Works pretty good.
Who is online
Users browsing this forum: No registered users and 2 guests