Wrist pin groove deburr tool
Moderator: John_Heard
- John_Heard
- Site Admin
- Posts: 5734
- Joined: Thu May 12, 2005 11:20 am
- Location: Resume Speed, Kansas
- Contact:
Wrist pin groove deburr tool
Been having full removing tru-arcs from my pistons, which often kicks up a little burr. That in turn makes it hard to get the pins out. After screwing around with a few different things to knock the burrs down I came up with this. It's just a old used pin with a cutter ground into the end of it. hard to see it but there is relief ground into the end so it will cut. Works pretty good.
My 1971 X275 Nova | Facebook
Who is online
Users browsing this forum: No registered users and 5 guests