Good morning
has anyone used this cam B4?
We have a 2900Lb 64 Falcon
Motor is a 5.0, rpm air gap, 600cfm, E7 heads I 213cfm@.55/ E 187cfm @.55 all at 28" of water.
Trans is C4/3500 stall TCI and 3:80 gears, 26 x 8 MT.
I was also wondering to get a little more lift and still keep the same valve seat to seat events I would like to use a 1:7 rocker.
Camshaft Specification Table
Part Number 35-552-8
Engine 1969-1995 Ford
351ci,
Windsor,
8cyl.
Grind Number FW NX264HR-14
Description
--------------------------------------------------------------------------------
Intake Exhaust
Valve Adjustment 0 0
Gross Valve Lift 0.512 0.512
Duration At 0.006 Tappet Lift 264 276
--------------------------------------------------------------------------------
Valve Timing At 0.006
Open Close
Intake 22 62
Exhaust 76 20
--------------------------------------------------------------------------------
These Specs Are For The Cam Installed At 110 Intake CL
Intake Exhaust
Duration At 0.05 212 218
Lobe Lift 0.32 0.32
Lobe Separation 114
--------------------------------------------------------------------------------
Recommended Valve Springs 986-16
any thoughts welcome
Thanks in advance
Jim
Comp cams Nx264hr-14
Moderator: John_Heard
Who is online
Users browsing this forum: No registered users and 30 guests