Bad - this makes the intake valve hit the piston and makes the motor builder want to throw up (at least until he figures out what he did wrong)...
![Pissed :pissed:](./images/smilies/Livid.gif)
![Rolling Eyes :roll:](./images/smilies/icon_rolleyes.gif)
![Image](http://i263.photobucket.com/albums/ii137/arkwoo/IMG_0163.jpg)
Good - this makes the motor builder feel stupid and good at the same time...
![Mr. Green :mrgreen:](./images/smilies/icon_mrgreen.gif)
![Rolling Eyes :roll:](./images/smilies/icon_rolleyes.gif)
![Image](http://i263.photobucket.com/albums/ii137/arkwoo/IMG_0172.jpg)
Degreeing the cam...
![Image](http://i263.photobucket.com/albums/ii137/arkwoo/IMG_0179.jpg)
Checking valve to piston clearance - 2 degrees at a time - geezo...
![Image](http://i263.photobucket.com/albums/ii137/arkwoo/IMG_0182.jpg)
Obtaining pushrod length...
![Image](http://i263.photobucket.com/albums/ii137/arkwoo/IMG_0184.jpg)
Here's the tools used...
![Image](http://i263.photobucket.com/albums/ii137/arkwoo/IMG_0186.jpg)
Just about finished with the short block - still need to check cam end-play again...
![Image](http://i263.photobucket.com/albums/ii137/arkwoo/IMG_0188.jpg)
And voila !!! One sexy new shortblock
![:smt003](./images/smilies/003.gif)
![:smt003](./images/smilies/003.gif)
![Image](http://i263.photobucket.com/albums/ii137/arkwoo/IMG_0190.jpg)