Car Craft Nitrous Plate Shootout
Moderator: John_Heard
- John_Heard
- Site Admin
- Posts: 5734
- Joined: Thu May 12, 2005 11:20 am
- Location: Resume Speed, Kansas
- Contact:
Car Craft Nitrous Plate Shootout
Car Craft Magazine had a pretty good nitrous plate comparision test in the November issue. They took plates from 6 manufacturers, NOS, Wilson, Speedtech, NX, Zex and Barry Grant and tried them on a 302 Ford that had like 9.5 compression. The Wilson plate took top honors with about 19hp over most of the other plates, the NX plate with the machined aluminum spray bar came in second. The other plates were pretty much the same peak HP producing about 200hp on a .063 jet. All of them were tested with the same set of NOS Big Shot Solenoids.
Pretty big eye opener that the plates were so close for me. I figured that new speedtech plate would generate some impressive numbers, it was about middle of the pack, but they did say it seemed to be more stable better than the other plates in terms of repeating the power levels and rpms where they peaked. I think NOS made a mistake in using their big shot plate for a 200 hp shot, they might have had better results using the cheater plate with it's lower flow potential at that HP level. I'd bet Wilson's phone is ringing off the hook today, they should be getting a lot more business soon.
Pretty big eye opener that the plates were so close for me. I figured that new speedtech plate would generate some impressive numbers, it was about middle of the pack, but they did say it seemed to be more stable better than the other plates in terms of repeating the power levels and rpms where they peaked. I think NOS made a mistake in using their big shot plate for a 200 hp shot, they might have had better results using the cheater plate with it's lower flow potential at that HP level. I'd bet Wilson's phone is ringing off the hook today, they should be getting a lot more business soon.
WILSON?? (nitrous oxide)
Beyond, The "Wilson" name. What's the web site? Thanks,Leon Snider
- John_Heard
- Site Admin
- Posts: 5734
- Joined: Thu May 12, 2005 11:20 am
- Location: Resume Speed, Kansas
- Contact:
- John_Heard
- Site Admin
- Posts: 5734
- Joined: Thu May 12, 2005 11:20 am
- Location: Resume Speed, Kansas
- Contact:
- John_Heard
- Site Admin
- Posts: 5734
- Joined: Thu May 12, 2005 11:20 am
- Location: Resume Speed, Kansas
- Contact:
Who is online
Users browsing this forum: No registered users and 10 guests