creeping fuel pressure at nos reg , ok for the street?
Moderator: John_Heard
-
- Posts: 44
- Joined: Mon Oct 22, 2007 5:51 pm
- Location: michigan
- Contact:
creeping fuel pressure at nos reg , ok for the street?
i have a 500 magnafuel pump and a magnafuel 2 port reg for carb i run a mallory reg for my 150 shot fogger , my question is .will the mallory reg for nos be ok with the pressure creep i get cause i dont use the nos much i know alot of folks use a dead head system but is that at the track ,where its not on for hours like on the street or should i invest in a 0.19 bleed and run it back to the cell thanks for your help...
mike , 1970 road runner 451 cu in indy 440-1 cyl heads, solid roller cam,T&D rockers 11.12 at 120 mph on motor.
- John_Heard
- Site Admin
- Posts: 5734
- Joined: Thu May 12, 2005 11:20 am
- Location: Resume Speed, Kansas
- Contact:
You'll get a lot of different opinons on this one... IMHO if you want to avoid pegging your gauge all the time when the nitrous is off put a bleed on it.
My 1971 X275 Nova | Facebook
-
- Posts: 44
- Joined: Mon Oct 22, 2007 5:51 pm
- Location: michigan
- Contact:
check out magnafuel.com under parts and accesories "fittings" part#3110 just install the fitting w/bleed after the regulator with a -3 line to the fuel tank or cell using a -3 bulkhead fitting unless you have multible stages of nos then you can use a fuel block and run a - 6 or a -8 line to cell or tank
mike , 1970 road runner 451 cu in indy 440-1 cyl heads, solid roller cam,T&D rockers 11.12 at 120 mph on motor.
Who is online
Users browsing this forum: No registered users and 1 guest